Writing with Symbols 2000 
How to make Multi Voiced Dialogue
This is a way to enjoy reading plays and poems by hearing them read
aloud with
different voices for different characters.
Open up the Symbol processor option. Type in the dialogue/text that you wish to use.
Don't use any punctuation and if you finish a line half way
across the page , press the space bar until the end of the
line. In this way you will get continuous speech.
Highlight the words that you want spoken in
a male voice. Click on the drop down voice icon and choose
a voice. Carry on selecting and choosing until the end of
the document 
Click on the Speech drop down menu and
make sure that it says 'Speech is On' 
Click on the speaker icon to hear the text read out
To add sound effects go to Sound on the
drop down menu and choose Add sound to graphic . Navigate
through to a sound after clicking Find Sound and follow
the 4 steps. Click on the speaker icon again to listen to
the text read and sound played.
You can add any sound to your text. Navigate
to any sound file or record your own voice or sound effect
by clicking on Start, Programs, Accessories, Entertainment and choose the sound recorder. Record your sound by
clicking the red square and speaking into the microphone then
clicking the red square again to stop. Save your sound file
in the usual way (File, Save As) then go through the last
bullet point again. It is a wonderful way to add richness
to the story and making it multi sensory
: 